Sub-Assembly Bracket, Removing And Installing: Installing

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

Replace the O-rings and seals.

-- Coat the new O-rings -4- with coolant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the connection pieces -2- into the engine oil cooler -1-.

-- Slide the sub-assembly bracket with the engine oil cooler -1- onto the connection. Position the bolts and tighten. Refer to Accessory Assembly Bracket - Tightening Specifications and Tightening Sequence .

-- Install the A/C compressor. Refer to A/C COMPRESSOR .

-- Install the generator. Refer to GENERATOR .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Install the oil filter and then check the oil level. 36.1.