LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2016 >> Golf Base, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System (Crankshaft & Cylinder Block - Service Information - CXBA, CNSA, CXBB, CNSB, CXCA, CXCB) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Overview - Cylinder Block, Belt Pulley Side >> Accessory Assembly Bracket - Tightening Specifications and Tightening Sequence >> Notes

Accessory Assembly Bracket - Tightening Specifications and Tightening Sequence: Notes

GWWA13-10887Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the accessory assembly bracket and then install the bolt -4- by hand.

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Tighten bolts in 3 stages in -1 to 5- sequence as follows:

Step Bolts Tightening Specification
1. -1 through 5- Tighten by hand
2. -1 through 5- 20 Nm
3. -1 through 5- Turn an additional 90°.
scientia non olet · About LEMON Manuals