LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2016 >> Golf Base, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System (Crankshaft & Cylinder Block - Service Information - CXBA, CNSA, CXBB, CNSB, CXCA, CXCB) >> 13 Crankshaft, Cylinder Block >> Crankshaft >> Crankshaft Needle Bearing, Replacing >> Installing

Crankshaft Needle Bearing, Replacing: Installing

GWWM13-10009Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the bearing seat in the crankshaft and thinly coat with grease.

-- Drive the needle bearing into the crankshaft up to the installation depth using the :VW207C  .

Installation Depth Dimension a = 2.0 mm 

GWWM13-10031Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

If the needle bearing was unintentionally pushed in too deeply, it must be replaced, because it will be damaged when it is removed again.

scientia non olet · About LEMON Manuals