Charge Pressure Actuator -V465-, ADJUSTING: Removing

-- Remove the bolt -2- and the screw-type clamp.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Remove the nuts -1 and 3-.

-- Remove bolts -arrows- and set the catalytic converter slightly aside.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:

• 01 - Engine Electronics 
• Guided Functions 
• 01 - Charge Pressure Actuator V465 Adjusting 

-- Adjust the charge pressure actuator linkage to the instructions in the Vehicle Diagnostic Tester.

-- Tighten the lock nut with the Mini Torque Wrench:VAS6854  .