Overview - Charge Air System
NOTE:
Assembly of screw-type clamps for the charge air hose connections. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
Before testing or performing a repair, check all air guide pipes and hoses and all vacuum lines for leaks and secure seating.
Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
- Air Guide Pipe
- Grommet
- Spacer Sleeve
- Bolt
- 7 Nm
- Air Guide Hose
- Installing. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Air Guide
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- Air Guide
- Rubber Bushing
- For the charge air cooler
- Rubber Bushing
- For the charge air cooler
- Bolt
- 7 Nm
- Spacer Sleeve
- Grommet
- Bolt
- 5 Nm
- Charge Air Pressure Sensor -G31-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING .
- O-ring
- Replace after removing
- Air Guide Hose
- Installing. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Air Guide Pipe