Electric Drive Power And Control Electronics, Replacing
WARNING: This page is about a different variant/trim than selected.
If the Electric Drive Power and Control Electronics -JX1- is replaced, always complete the following adaptations in the order listed:
Connect the Vehicle Diagnostic Tester.
-- Select Guided Functions .
-- Using the GO TO button, select the following menu points:
1. Adapt the Electric Drive Power and Control Electronics -JX1- to the immobilizer.
- Body
- Electrical Equipment
- OBD-capable systems
- 51 - Electric drive J841
- 51 - Electric drive functions
- Adapt electric drive power and control electronics to immobilizer
2. Code the Electric Drive Power and Control Electronics -JX1-
- Body
- Electrical Equipment
- OBD-capable systems
- 51 - Electric drive J841
- 51 - Electric drive functions
- 51 - Code control module (repair group 93)
3. Calibrate the Electro-Drive Drive Motor -V141-.
- Body
- Electrical Equipment
- OBD-capable systems
- 51 - Electric drive J841
- 51 - Electric drive functions
- 51 - Calibrate electro-drive drive motor (repair group 93)