Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

The engine is cold.

-- Quickly open the coolant expansion tank cap -arrow- and release any remaining pressure in the cooling system and then close it again until it locks.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Place a cloth underneath to catch any escaping coolant.

To prevent coolant loss, immediately insert the new Engine Coolant Temperature Sensor -G62- in the connection.

-- Remove the bolts -2-, and remove the Engine Coolant Temperature Sensor -G62- -3-.