LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Cooling System (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 19 Cooling System >> Coolant Pump/Coolant Regulation >> Electric Coolant Pump, Removing And Installing >> Heater Support Pump -V488-, REMOVING AND INSTALLING, VERSION 2 >> Installing

Heater Support Pump -V488-, REMOVING AND INSTALLING, VERSION 2: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Secure all hose connections with standard production hose clamps.

If the Heater Support Pump -V488- was removed from the bracket

-- Make sure the rubber bushing is seated correctly in the bracket.

-- Make sure the spacer sleeves are seated correctly in the rubber bushing.

-- Tighten the bolts.

-- Check the coolant level. Refer to COOLANT, FILLING .

scientia non olet · About LEMON Manuals