Engine Coolant Temperature Sensor on Radiator Outlet -G83-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

The engine is cold.

-- Briefly open the coolant expansion tank cap -arrow- and release any residual pressure in the cooling system and then close it again until it locks.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Disconnect the connector -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Place a cloth underneath to catch any escaping coolant.

-- Remove the clamp -1- and pull the Engine Coolant Temperature Sensor on Radiator Outlet -G83- off the connection -3-.