Low Temperature Circuit Coolant Pump -V468-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Open the coolant reservoir cap -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

The cooling system is under pressure when the engine is warm. Risk of scalding due to hot steam and hot coolant.

Scalding the skin and other parts of the body is possible.

- Wear safety gloves.

- Wear protective eyewear.

- Reduce the pressure by covering the coolant expansion tank cap with a cloth and carefully opening it.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Disconnect the connector -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -5 and 6-.

-- Guide the Low Temperature Circuit Coolant Pump -V468- downward to loosen the coolant hoses -4-.

-- Place the :VAS6208 underneath.

-- Clamp off the coolant hoses on the Low Temperature Circuit Coolant Pump -V468- with the :3094 .

-- Loosen the clamps -3- and remove the coolant hoses.

-- Remove the Low Temperature Circuit Coolant Pump -V468- with the bracket attached.