Left Seal, Replacing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the left wheel.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Remove the lower section of the left front wheel housing liner or the left front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Remove the left drive axle. Refer to DRIVE AXLE .

-- Place a Drip Tray for example Shop Crane - Drip Tray :VAS6208 or Used Oil Collection and Extraction Unit :SMN372500 underneath.

-- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using a pry bar.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the flange shaft and the pressure spring.

-- Remove flange shaft seal.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.