Removing Outer Race/Tapered Roller Bearing

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - Counter Support, for example, Puller - Kukko Counterstay :Kukko 22/2

B - Internal Puller 46 to 58 mm, for example, Puller - Kukko Internal - 46-56mm :Kukko 21/7

NOTE:

Tension the Internal Puller -B- between the outer race/tapered roller bearing and shim tightly. Refer to -item ) Washer-.

Check the shim for damage after removing it. Replace, if necessary.

Instead of the Puller - Kukko Internal - 46-56mm :Kukko 21/7 the Puller - Kukko Internal - 56-70mm :Kukko 21/8 can also be used.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - Counter Support, for example, Puller - Kukko Counterstay :Kukko 22/2

Counter Support, for example, Puller - Kukko Counterstay :Kukko 22/2

B - Internal Puller 46 to 58 mm, for example, Puller - Kukko Internal - 46-56mm :Kukko 21/7

NOTE:

Instead of the Puller - Kukko Internal - 46-56mm :Kukko 21/7 the Puller - Kukko Internal - 56-70mm :Kukko 21/8 can also be used.