Right Seal, Replacing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Turn steering as far as possible toward right.

-- Remove the drive axle heat shield, if equipped, from the engine -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the drive axle from the flange shaft.

-- Tie the drive axle as high up as possible. Do not damage the paint on the drive axle.

-- Place the Drip Tray under the transmission.

-- Remove bolts for flange shaft, by installing two bolts into the flange and counter-holding flange shaft using a pry bar.

-- Remove the flange shaft and the pressure spring.

-- Remove the flange seal using the :VW771 and the :VW771/37 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.