Left Seal, Replacing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the left wheel.
-- Remove the noise insulation. Refer to NOISE INSULATION .
-- Remove the lower section of the left front wheel housing liner or the left front wheel housing liner. Refer to WHEEL HOUSING LINER .
-- Turn the steering wheel to the left.
-- Remove drive axle from flange shaft; Refer to DRIVE AXLE .
-- Tie the drive axle as high up as possible. Do not damage the paint on the drive axle.
-- Place the Drip Tray under the transmission.
-- Remove bolts for flange shaft, by installing two bolts into the flange and counter-holding flange shaft using a pry bar.
-- Remove the flange shaft and the pressure spring.
-- Remove the flange seal using the :VW771 and the :VW771/37 .