Dual Clutch, Removing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the clutch end cover. Refer to CLUTCH END COVER, REMOVING AND INSTALLING .

-- Pry out the drive plate circlip -2- with a screwdriver -1- in direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the drive plate in direction of -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the circlip -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

This circlip must be replaced and re-measured during installation.

CAUTION:

Carefully remove the dual clutch. Make sure that no other parts of the clutch fall out. Never turn over the clutch for this reason!

-- Carefully remove the dual clutch from the transmission.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the pump shaft -A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- The pump shaft will be inserted first after the installation of the new clutch. Set the shaft down until then.

-- Install the dual clutch. Refer to DUAL CLUTCH, INSTALLING .