Dual Clutch, Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Clutch Retaining Bar :T10303
Requirement:
- To install the clutch, the transmission must be secured in a vertical position on the assembly stand. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
- The large lamella carrier is inserted in all clutch discs in the clutch. The large lamella carrier must not slipped out of the lowest clutch disc.
- Adjust the clutch axial play when installing.
- Transmission fluid pump shaft is removed.
- Do not install any wavy circlips