Clutch End Cover, Removing And Installing: Notes
Special Tools And Workshop Equipment Required
- Clutch Cover Plate Guide Sleeve :T10302
Clean the :T10302 before using, and do not use any scratched sleeves
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Gasket - Check/drain plug
- Circlip - Clutch end cover
Brief Description
The clutch end cover seals the transmission toward the outside. A circlip holds the clutch end cover in place. After the circlip has been removed, the clutch end cover can be pried out. Always replace the clutch end cover and the circlip. Never use a hammer to install a new clutch end cover and never lubricate the center seal or touch it. If this happens, the clutch end cover will certainly leak!
The transmission must be removed in order to work on the cover.
-- Remove the transmission. Refer to TRANSMISSION, REMOVING AND INSTALLING .
-- Secure the transmission on the assembly stand. Refer to TRANSMISSION, TRANSPORTING .