Clutch Housing, Servicing
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Press Piece - Multiple Use Spacer Sleeve :VW472/2
- Press Piece - Pad :30-555
- Seal Installer - Driver Set :3066
- Press Piece - Pivot Mount Bushing :3124
- -2- Puller - Kukko Puller - 60-150 mm Width, 200 mm Length :18/1
- -3- Puller - Kukko Quick Action Separating Tool - 12-75 mm :17/1
-- Place the : VW472/2 and :30-555 on the differential.
A - Puller, for example, :18/1
B - Puller, for example, :17/1
A - Threaded studs from :3066 installed in differential threaded piece
B - M 12 Nut with Washer
-- Turn the nut -B- and pull the sleeve all the way over the :3124 .
NOTE:
If transmission is disassembled, press sleeve in onto stop using :3124 .