Selector Mechanism, Disassembling And Assembling: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Window Release Tool :T10236
- Press Piece - Multiple Use :VW412
- Over-Center Spring Assembly Tool :T10178 or flat iron, 200 x 25 x 5 mm
- Engine Support Bridge - Engine Support 25 :10-222A/25 or flat iron, 350 X 30 X 5 mm
- - 4- = Puller - Counter stay, for example :22/4
- Wedge :T10357
- Press Piece - Block :T10083
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Base plate
- Lock washers - Cable ends to selector housing
- Seal - Selector housing