Gearshift Knob, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Clamp - Gearshift knob
-- Remove the boot with the center console cover from the center console or pry it out carefully -arrows-.
NOTE:
It may be necessary to pry off the boot in the front area on some models.
-- Fold the boot with the center console cover up over the shifter knob.
-- Open the clamp -arrow- and remove the shift knob and boot.
In some equipment versions, the center console cover remains in the center console.
-- Pull the center console cover out or pry it out carefully.
-- Remove the noise insulation -1-.