Securing On Engine And Transmission Holder, Fastening Hole Located On Side Of Transmission
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Gearbox Support :3221 (checking and if necessary adjusting. Refer to the illustration below)
- or Gearbox Support :3221A
- Holding Fixture :VW313
The transmission is secured on the transmission support fastening hole.
The fastening hole is located on the side of the transmission. Refer to Figure
-- If necessary drill a 11.0 mm diameter hole -arrow-.
-- The label the :3221 as :3221A .
-- Secure the transmission on the :3221A -arrows-.