Overview - Clutch
WARNING: This page is about a different variant/trim than selected.
- Flywheel
- Make sure it fits securely on the centering pins
- Removing and installing. Refer to CYLINDER BLOCK, TRANSMISSION SIDE (CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA) , CYLINDER BLOCK, TRANSMISSION SIDE (CZCA, CZDA, CZTA) , CYLINDER BLOCK, TRANSMISSION SIDE (CBPA, CKJA) , CYLINDER BLOCK, TRANSMISSION SIDE (CNLA, CRJA) or CYLINDER BLOCK, TRANSMISSION SIDE (CPLA, CPPA, CPKA, CPRA) .
- Clutch Plate
- For allocation refer to the Parts information.
- Installed location: The spring cage faces the pressure plate
- Lightly grease the splines
- Pressure Plate
- Check the ends of the diaphragm spring. Refer to Figure
- Bolt
- M 6: 13 Nm
- M 7: 20 Nm
- Loosen and tighten in small steps and in diagonal sequence
- For allocation refer to the Parts information.