DSG® Clutch, Removing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- T-Handle Hook :3438
- Engine Bung Set :VAS6122
- Support Bridge :T10323
- Subframe Bushing Assembly Tool Kit -Assembly Tool 5 :T10356/5 from the Subframe Bushing Assembly Tool Kit :T10356
- Puller - Clutch :T10373
- Clutch Press Piece :T10376
- Protective Cap :0AM 325 120 A quantity 1 and Protective Cap :02M 409 120 quantity 1, as an alternative to the Engine Bung Set :VAS6122
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Cap/Vent - On transmission
- Locking Rings - Transmission
Requirement
- The transmission is removed and mounted to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
- The DSG Transmission Mechatronic -J743- is installed in the transmission.
- The connection on the valve block/Mechatronic is sealed with a new sealing plug -arrow- from the Repair Kit :5C0 998 152
.