Clutch, Removing And Installing, With Dual Mass Flywheel, SACHS: Removing
WARNING: This page is about a different variant/trim than selected.
- The transmission is removed.
-- Insert the Flywheel Retainer : 3067 to loosen the bolts.
When Removing, Loosen The Bolts As Follows So That The Clutch Pressure Plate Does Not Distort (Causing Shuddering On Acceleration):
-- Loosen the bolt diagonally in small steps.
- When loosening, the stop -2- and the bolt -1- must loosen up together.
-- If the stop does not loosen: push the bolt toward the dual mass flywheel.
-- Remove the pressure plate and the clutch plate.