Overview - Pedal Assembly: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Lubricate all bearing areas and contact surfaces.
Grease allocation.
- Bulkhead
- With a mount for the bracket
- Seal
- Between the bracket and bulkhead
- Self-adhesive
- replace after removing the bracket
- Attached to the bracket
- Bracket
- For the clutch pedal mount
- some equipment versions have a damper. Refer to Clutch Bracket With Sound Absorber .
- Removing and Installing. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .
- Bolt
- Over-Center Spring
- Removing and Installing. Refer to OVER-CENTER SPRING, REMOVING AND INSTALLING .
- Bearing Bushing
- Mounting Pin
- Clutch Pedal
- Removing and Installing. Refer to CLUTCH PEDAL, REMOVING AND INSTALLING .
- Base Plate
- To remove and install, disconnect the clutch master cylinder from the clutch pedal. Refer to CLUTCH PEDAL, REMOVING AND INSTALLING .
- Seal
- Between the clutch master cylinder and the bracket
- Replace after removing
- Clutch Master Cylinder
- Removing and installing after removing the bracket. Refer to CLUTCH MASTER CYLINDER, REMOVING AND INSTALLING
- Clutch Position Sensor -G476-
- Can be checked in Guided Fault Finding using the Vehicle Diagnostic Tester.
- For allocation refer to the Parts information.
- Removing and Installing. Refer to Clutch Position Sensor -G476-, REMOVING AND INSTALLING .
- Clamp
- To remove and install the hose/line assembly or pipe, pull the clamp all the way out.
- Supply Hose
- Made of plastic. Refer to Brake Booster/Fluid Reservoir Supply Hose & Seals .
- Nut
- 25 Nm
- Replace after removing
- Self-locking
- For the bracket to the bulkhead
- Quantity: 3
- Nut
- 25 Nm
- Replace after removing
- Self-locking
- Stop
- For the clutch pedal