Over-Center Spring, Removing And Installing: Removing

Vehicles With A Knee Airbag 

-- Determine whether a coded radio is installed. If so, obtain the anti-theft code.

-- Disconnect the battery ground cable. Refer to BATTERY .

Continuation For All 

-- Move the driver seat all the way back and raise the steering wheel to the highest position.

-- Remove the trim and the cover under the trim on the driver side. Refer to STORAGE COMPARTMENTS AND COVERS .

Vehicles With A Knee Airbag 

-- Remove the knee airbag bracket and crash bolster.

Continuation For All 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cable guide -2- from the steering column.

-- Remove the footwell vent -3-. Refer to AIR DUCT .

Vehicles Without Knee Airbag 

There are different ways of securing the impact bolster -1- in front of the clutch pedal -2-. The crash bolster may look different than what is shown in the following illustrations.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing With Two Bolts 

-- Remove the crash bolster -1- (2 bolts).

Securing With One Bolt 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the crash bolster -1- (1 bolt -2-).

Continuation For All 

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper -arrow- at the bottom of the bracket/clutch pedal, if equipped.

-- Remove the washers -A- for the damper.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper.

-- Push the damper near the upper nut -1- above the clutch pedal -A- in direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the clutch pedal -1- from the bracket -3-. To do this, remove the nut -2- and bolt -5-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Swivel the clutch pedal slightly downward and remove the over-center spring -4- from the bracket.