LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Clutch System (Service Information - Manual Transmission - 02Q, 02QA)) >> 30 Clutch >> Clutch Mechanism >> Mounting Bracket, Removing And Installing >> Installing

Mounting Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Replace the self-locking nuts.

Replace the hose clamps

Allocate all components according to the Parts information.

Some vehicles have a damper -arrow- on the mounting bracket/clutch pedal.

GWWN30-10195Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vehicles Without Knee Airbag 

There are different ways of securing the impact bolster -1- in front of the clutch pedal -2-.

GWWN34-10315Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing With Two Bolts 

-- Install the crash bolster -1- and tighten the 2 bolts to the tightening specification.

Securing With One Bolt 

GWWN30-10117Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the crash bolster -1- and tighten the bolt -2- to the tightening specification.

Continuation For All 

GWWN30-10001Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the cable guide -2- to the steering column.

-- Install the footwell vent -3-. Refer to AIR DUCT .

Vehicles With A Knee Airbag 

-- Install the knee airbag bracket and crash bolster.

Continuation For All 

-- Install the trim and the cover under the trim on the driver side. Refer to STORAGE COMPARTMENTS AND COVERS .

-- Press the hose/line assembly or plastic line -1- into the master cylinder connection -4- with the new seal -2- until the securing clip -3- audibly locks into place.

GWWA30-0156Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the line to make sure it is secure.

-- After removing the Hose Clamps - Up To 25mm :3094  bring the return hose back to its original shape.

-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .

-- Install the battery. Refer to BATTERY . .

-- If removed, install the complete air filter housing. Refer to AIR FILTER (CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA) or AIR FILTER (CNLA, CRJA) , AIR FILTER (CZCA, CZDA, CZTA) , [For engine(s) CZTA] Air Filter , AIR FILTER (CBPA, CKJA) and AIR FILTER (CPLA, CPPA, CPKA, CPRA) .

-- Disconnect the battery. Refer to BATTERY .