LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Clutch System (Service Information - Manual Transmission - 02Q, 02QA)) >> 30 Clutch >> Clutch Mechanism >> Clutch Position Sensor -G476-, REMOVING AND INSTALLING >> Installing

Clutch Position Sensor -G476-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Allocate all components according to the Parts information.

If The Hose/Line Assembly Was Removed: 

-- Install the hose/line assembly -1- or the pipe with the seal -2- on the clutch master cylinder connection -4- until the clamp -3- audibly engages.

GWWA30-0156Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly and pipe to make sure it is secure.

-- After removing the Hose Clamps - Up To 25mm :3094  bring the return hose back to its original shape.

-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .

-- Install the battery tray and the battery. Refer to Drive Belt Routing .

-- If removed, install the complete air filter housing. Refer to AIR FILTER (CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA) or AIR FILTER (CNLA, CRJA) , AIR FILTER (CZCA, CZDA, CZTA) , AIR FILTER (CBPA, CKJA) and AIR FILTER (CPLA, CPPA, CPKA, CPRA) .

-- Connect the battery and follow the procedure regarding what to do after connecting a battery. Refer to BATTERY . .

scientia non olet · About LEMON Manuals