Clutch Mechanism Lines, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the complete air filter housing if the lines are not accessible. Refer to AIR FILTER (CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA) or AIR FILTER (CNLA, CRJA) , AIR FILTER (CZCA, CZDA, CZTA) , AIR FILTER (CBPA, CKJA) and AIR FILTER (CPLA, CPPA, CPKA, CPRA) .

NOTE:

Be careful not to get any brake fluid on the longitudinal member or on the transmission when performing the following work. If it does, clean the areas thoroughly.

-- Unclamp the supply hose -2- to the clutch master cylinder with a Hose Clamps - Up To 25mm :3094 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

A slight deformation of the supply hose remains after the Hose Clamps - Up To 25mm :3094 have been unclamped.

The supply hose is therefore not defective.

After removing the Hose Clamp up to 25 mm :3094 , the supply hose must be formed back into its original shape.

Remove the hose/line assembly or pipe on clutch master cylinder as follows:

-- Open the clamp -3- with a screwdriver and remove the line -1- and O-ring -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Do not press the clutch pedal after removing the line.

Remove the hose line or pipe on bleeder as follows:

-- Release the clip -2- with a screwdriver or a pointed tool and remove the line -4- with O-ring -3- from the bleeder -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.