Clutch Mechanism Lines, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
-- Install the hose/line assembly or pipe -1- with the O-ring -2- on the clutch master cylinder connection -4- until the clamp -3- audibly engages.
-- Pull on the line to make sure it is secure.
-- Press the line with O-ring -3- on the bleeder connection until the clamp audibly engages.
-- Pull on the line to make sure it is secure.
- After removing the Hose Clamp up to 25 mm :3094 , the supply hose must be formed back into its original shape.
-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .
-- Install the complete air filter housing. Refer to AIR FILTER (CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA) or AIR FILTER (CNLA, CRJA) , AIR FILTER (CZCA, CZDA, CZTA) , AIR FILTER (CBPA, CKJA) and AIR FILTER (CPLA, CPPA, CPKA, CPRA) .