Clutch Master Cylinder, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Before replacing the clutch master cylinder due to an assumed defect, perform the Guided Fault Finding Vehicle Diagnostic Tester first.
When working inside the footwell, cover the carpet with cloths to protect it from leaking brake fluid.
-- Remove the bracket. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .
-- Release the mount for the clutch master cylinder actuator rod using the Clutch Pedal Pliers :T10005 .
-- Place a spacer -A- between the clutch pedal and stop. Press the clutch pedal to the spacer while doing so.
- Length of spacer = approximately 40 mm (for example 1 /2 " socket insert)
-- Unlock the securing clip -B- and remove the clutch master cylinder from the bracket -arrow 1- and -arrow 2-.