Bleeder, Removing And Installing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To remove, release the clip -2- with a screwdriver or a pointed tool and pull off hose/line assembly or pipe -4- from the bleeder -1-.

-- To install, press hose/line assembly or pipe with new O-ring -3- onto the bleeder connection, until clip audibly engages.

-- Pull on the line to make sure it is secure.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To remove, release the clip -2- with a screwdriver or a pointed tool and remove the bleeder -4- from the clutch slave cylinder -1-.

-- To install, check the O-ring -3- on the clutch slave cylinder. Press in the bleeder at the clutch slave cylinder connector until the clip -2- engages audibly.

-- To check, pull on the bleeder.

-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .