LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Diesel Fuel Injection System (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 23 Diesel Fuel Injection >> Sensors >> Exhaust Pressure Sensor 1 -G450-, REMOVING AND INSTALLING >> Installing

Exhaust Pressure Sensor 1 -G450-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Before installing, blow compressed air in the direction of the particulate filter to clean the control lines from the Exhaust Pressure Sensor 1 -G450- to the particulate filter (plugged or iced over due to condensation water).

Check the hose for secure fit and leaks.

Secure all hose connections with standard production hose clamps.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- After replacing the Exhaust Pressure Sensor 1 -G450-, reset the adaptation values with the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals