LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Diesel Fuel Injection System (General & Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 23 Diesel Fuel Injection >> Engine Control Module >> Engine Control Module -J623-, REMOVING AND INSTALLING >> Engine Control Module -J623- WITH PROTECTIVE HOUSING, REMOVING AND INSTALLING >> Notes

Engine Control Module -J623- WITH PROTECTIVE HOUSING, REMOVING AND INSTALLING: Notes

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required 

NOTE:

If it is necessary to replace the engine control module, connect the Vehicle Diagnostic Tester and perform "Replace control module" function.

Shear bolts attach the protective housing. It is not possible to remove the shear bolts without damaging them. Use :VAS6682  or a cutting grinder to remove the shear bolts. The protective housing must be replaced if it was damaged.

scientia non olet · About LEMON Manuals