Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

Component	Tightening Specification
Threaded connection -2-	50 Nm

Fig 1: Lower Section of Oil Pan - Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in steps in the sequence -1 to 19- :

Step	Component	Tightening Specification
1	Bolts -1 through 19-	Install by hand all the way
2	Bolts -1 through 19-	12 Nm

Fig 2: Upper Section of Oil Pan - Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence:

Step	Component	Tightening Specification/Additional Turn
1	Bolts -1 to 19-	Install by hand all the way
2	Bolts -arrows-	Install by hand all the way
3	Bolts -1 to 19-	8 Nm
4	Bolts -1 to 19-	90° additional turn
5	Bolts -arrows-	Tightening specification. Refer to the appropriate information TRANSMISSION, REMOVING AND INSTALLING (02Q, 02QA) , TRANSMISSION, REMOVING AND INSTALLING (0CG) and TRANSMISSION, REMOVING AND INSTALLING (0AF) .