Oil Pan Lower Section, Removing And Installing: Installing

-- Cover open engine components.

-- Spray the sealing surface with sealant remover and allow it to work.

-- Remove any sealant residue on the oil pan upper section using a flat-blade scraper.

-- Remove any remaining sealant from the oil pan lower section using, for example, a rotating plastic brush.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean any oil or grease off the sealing surfaces.

NOTE:

Be sure to check the expiration date of the sealant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Cut the tube nozzle at the front marking (nozzle diameter: about 2 mm).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Apply a sealant bead -arrow- to the clean sealing surface on the lower section of the oil pan as shown.

• Do not apply sealant bead thicker than indicated.
• Sealant bead thickness: 2 to 3 mm.

-- Apply the sealant bead very carefully near the sealing flange.

-- The oil pan lower section must be installed within five minutes of applying the sealant.

-- Position the oil pan lower section and tighten the bolts. Refer to Figure.

-- Install the Oil Level Thermal Sensor -G266-. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .

• After installing the oil pan lower section, let the sealant harden for about 30 minutes. Only afterward may the engine oil be replenished.

-- Fill the engine oil and check the oil level.