Securing On Engine And Transmission Holder
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Holding Plate :VW309A
- Transmission Support :VW353
- Engine and Gearbox Bracket :VAS6095A
Procedure
-- Secure the transmission with the Transmission Support :VW353 to the Holding Plate :VW309 -arrows-.
NOTE:
If one of the fastening holes does not touch the Transmission Support, place washers between the fastening hole and the Transmission Support.
-- Insert the Holding Plate : VW309 in the Engine and Gearbox Bracket :VAS6095A .