Engine, Removing: Notes

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required

Engine and Gearbox Jack :VAS6931
Engine Bung Set :VAS6122
Shop Crane - Drip Tray :VAS6208
Hose Clip Pliers :VAS6362
Locking Pin :T10060A
Engine Support :T10497A with Pin :T10497/1
Engine Support - Clamp :T10497/4
Pry Lever :80-200
Protective Mat :VAS531003
Commercially Available Step Ladder
Protective Eyewear
Safety Gloves

CAUTION:

After installing a new short block it is required after the installation of the high pressure line to tensioning claw the tensioning brackets of the fuel injectors to the specified tightening specification. Refer to OVERVIEW - FUEL INJECTORS . Only tighten the tensioning claws >>hand tight<< after delivery when assembling the high pressure lines in order to align the fuel injectors. Engine damage may occur if not observed.