Engine And Transmission, Separating: Procedure

WARNING: This page is about a different variant/trim than selected.

-- Remove the starter. Refer to STARTER .

-- Remove the bolts -arrows- and remove the transmission support.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the :T40013 on the transmission and close the retainer.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Engage the :VAS6100 on the lifting tackle using the :10-222A/2 .

-- Remove the bolts -1, 2, 5, 6, 7 and 8- connecting the transmission to the engine.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the transmission from the engine, pay attention to the intermediate plate while doing so.