Transmission Mount, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Battery tray. Refer to BATTERY .
-- Remove the Engine/Motor Control Module -J623- from the bracket. Refer to ENGINE CONTROL MODULE .
-- Unclip the wiring guide -1- upward in direction of -arrows- and move it slightly to the side.
-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .
-- Remove the bolts -2-, then the bolts -arrows- and remove the transmission mount -1-.