Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

Fig 1: Assembly Mounts Tightening Sequence (1 of 2)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in steps in the sequence -1 to 3- :

Step	Bolts	Tightening Specification/Additional Turn
1	-1 through 3-	7 Nm
2	-1 through 3-	40 Nm
3	-1 through 3-	180° additional turn

Fig 2: Assembly Mounts Tightening Sequence (2 of 2)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- First fasten the pendulum support -4- to the transmission and then to the subframe.

-- Tighten the bolts in the steps shown in the sequence:

Step	Bolts	Tightening Specification/Additional Turn
1	-2 and 3-	50 Nm
2	-1-	100 Nm
3	-1 through 3-	90° additional turn