LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Engine Assembly System (Service Information - CVCA, CUUA, CUUB, DELA, DEBA, DEJA, DGMA)) >> 10 Engine Assembly >> Assembly Mounts >> Overview - Assembly Mounts >> Notes

Overview - Assembly Mounts: Notes

WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Assembly Mounts
GWWM10-10098Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Bolt
    • Tightening specification. Refer to Figure
    • Replace after removing.
    • Engine support to engine
  2. Engine Mount
  3. Bolt
    • 40 Nm + 90°
    • Replace after removing.
    • Engine mount to body
  4. Bracket
  5. Bolt
    • 20 Nm + 90°
    • Replace after removing.
    • Bracket to engine mount and body
  6. Bolt
    • 40 Nm + 90°
    • Replace after removing.
    • Engine mount to body
  7. Bolts
    • 60 Nm +90°
    • Replace after removing.
    • Engine mount to engine support
  8. Pendulum Support
    • Removing and installing. Refer to Figure.
    • First install the pendulum support to the transmission and then to the subframe
  9. Bolt
    • Tightening specification. Refer to Figure
    • Replace after removing.
    • Pendulum support to subframe
  10. Bolts
    • Tightening specification. Refer to Figure
    • Replace after removing.
    • Pendulum support to transmission
  11. Bolt
    • 60 Nm +90°
    • Replace after removing.
    • Transmission mount to transmission support
  12. Bolt
    • 40 Nm + 90°
    • Replace after removing.
    • Transmission mount to body
  13. Transmission Mount
    • The illustration shows the DSG® transmission version
  14. Transmission Support
  15. Bolt

    Tightening specification:

  16. Bolt

    Tightening Specification: 

  17. Engine Support
scientia non olet · About LEMON Manuals