Assembly Mount, Adjusting: Notes

-- Support the engine with the transmission but do not lift it. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Replace the assembly mount bolts -1, 3, and 5- one after the other as long as this was not already done when installing the engine and hand tighten.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the assembly mounts bolts -2- one after the other (if it was not already performed with the engine was installed) and tighten hand-tight.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the left and right support arm bolts just enough so that the mount can still be moved.

• There must be a distance -a- of 10 mm between the engine support and right longitudinal member.

  Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• The casting edge on the engine support must be parallel to the engine mount support arm.
• Dimension -b- = dimension -b-.

-- Make sure that the edges of the support arm -2- and transmission mount -1- are parallel on the transmission side.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Dimension -x- is the same size on both sides of the mount.

-- Tighten the assembly mount bolts.

Perform the rest of the installation in the reverse order of removal.