MECHATRONIC Hydraulic Fluid, Draining And Filling: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit :SMN372500
- Engine Bung Set :VAS6122
- Funnel, Commercially Available
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Drain Plug
The Mechatronic hydraulic fluid is permanently filled. It is not possible to check the fluid level.
CAUTION:
Risk of causing damage to the Mechatronic.
- Only the hydraulic fluid for the Mechatronic that is available as a replacement part may be used. Refer to the Parts information.
- Using other fluids can cause malfunctions or Mechatronic failure.
- Checking the hydraulic fluid level in the Dual-Clutch Transmission Mechatronic -J743- is not possible. The vent on the Dual-Clutch Transmission Mechatronic -J743- must be sealed tight for performing any assembly work. Fluid that has leaked out of the DSG Transmission Mechatronic -J743- hydraulic area may not be checked.
- Fluid that has leaked out can only be adjusted correctly when changing the hydraulic fluid. It is not possible to check the fluid level.
- Under filling or overfilling will impair the function of the Mechatronic.
Requirements
- Mechatronic is removed. Refer to MECHATRONIC, REMOVING AND INSTALLING .