Transmission Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Bolt that were tightened with an additional turn must be replaced.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Risk of damaging threads in transmission bracket by inserting bolts crooked.

The transmission bracket -1- and the transmission mount support arm must be absolutely parallel to each other before installing the bolts -arrows-. If necessary, lift the back of the transmission with a floor jack or a transmission jack.
Only remove the Engine Support Bridge :10-222A when bolts for subframe mount are tightened to tightening specification.

-- Lift the transmission using the spindle on the Engine Support Bridge until the transmission bracket touches the support arm on the transmission mount.

-- Check the subframe mount adjustment. Refer to SUBFRAME MOUNT [For engine(s) CZTA] or SUBFRAME MOUNT [For engine(s) CBPA] or SUBFRAME MOUNT [For engine(s) CNLA] or SUBFRAME MOUNT [For engine(s) CPPA, CPRA, CPKA, CPLA] .

-- Remove the Engine Support Bridge :10-222A from the engine.

Install the Electric Drive Power and Control Electronics -JX1-. Refer to ELECTRIC DRIVE POWER AND CONTROL ELECTRONICS .

-- Energize the high voltage system and complete the required documentation. Refer to HIGH VOLTAGE SYSTEM GENERAL WARNINGS .