Boot With Clutch Positioner, Replacing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Refer to the Parts information for the correct cleaning solution.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Seal - Mechatronic
CAUTION:
Risk of causing damage to the Mechatronic
- To perform a problem-free and successful repair, extreme caution and cleanliness, as well as properly functioning tools are an important requirement.
- The clutch positioner pistons are magnetic. Remove the new clutch positioner from the packaging just before installing to ensure the greatest cleanliness.
- Install the clutch positioner right after removing from the packaging, do not set it down before installing.
Requirements
- The Mechatronic is removed and the Mechatronic bleed hole is sealed tightly. Refer to MECHATRONIC, REMOVING AND INSTALLING ,