LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Gears & Shafts System (Service Information - Direct Shift Gearbox - 0CG)) >> 35 Gears, Shafts >> Parking Lock >> Parking Lock Cover, Removing And Installing >> Installing

Parking Lock Cover, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

The parking lock cover must be replaced if there are leaks on the gearshift shaft seal or on the parking lock cover.

-- Clean the sealing surface and the parking lock cover -1-.

-- Install the parking lock cover -1- and the bolts -2-.

-- Install the selector lever -4- and the bolt -3-.

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- The rest of the installation is performed in reverse order of removal. When doing this, install the Electric Drive Power And Control Electronics -JX1-. Refer to ELECTRO-DRIVE DRIVE MOTOR .

-- Energize the high voltage system and complete the required documentation. Refer to HIGH VOLTAGE SYSTEM, TURNING BACK ON .

scientia non olet · About LEMON Manuals