Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
NOTE:
The tightening specifications only apply to lightly greased, oiled, phosphated or blackened nuts and bolts.
Additional lubricants, such as engine or transmission oil are permissible, although lubricants containing graphite are not.
Do not use any ungreased parts.
Tightening specification tolerance: ±15%.
| Component | Bolts and nuts | Nm |
|---|---|---|
| M 6 | 10 | |
| M 7 | 15 | |
| M 8 | 20 | |
| M 10 | 40 | |
| M 12 | 65 | |