Vibration Damper Sealing Ring, Replacing: Installing

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the contact and sealing surface.

-- Push the seal -arrow- on the :T10354 .

-- Push the seal -arrow- with the :T10354 on the :T10531/2 and place on the lower timing chain cover.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Additionally attach the :T10375 and tighten the :T10531/4 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Drive the seal in all the way using the :T10354 .

NOTE:

Replace the vibration damper bolt.

Replace the O-ring.

Further assembly is performed in the reverse order of the removal. Note the following:

-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .