Removing Inner Race/Tapered Roller Bearing

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Note the following before installing the Tapered Roller Bearing Puller:

-- Remove the inner race/tapered roller bearing locking ring on the side facing the transmission housing.

-- Place the Press Piece - Multiple Use :VW431 and Press Piece - Multiple Use :40-105 on the output shaft.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the Press Piece - Multiple Use :30-11 on the output shaft before removing the puller.

Assemble the Output Shaft

NOTE:

Heat the tapered bearing inner races and synchronizer hub to approximately 100 °C (212 °F) with the Inductive Heat Unit :VAS6414 before installing. Press on to the stop so that there is no axial clearance when assembling.